Control Panels


Control Equipment

The following are generally required to be fitted as standard to the enclosure backplate. Other equipment may be specified:-


• A Single Pole & Neutral (SPN) or Three Phase & Neutral (TPSN) incoming isolator or fuse switch, with door interlocking facility.
• A suitable number of MCB’s or BS88 fuse carriers for outgoing and auxiliary circuits - type, number and ratings as specified.
• A Neutral shrouded terminal busbar for connection of up to 11 x 25mm² cables in addition to the control panel internal wiring.
• Enclosure body, door and chassis plate fully bonded to the earth bar.
• Relevant circuit identification and Safety Earth labels.

Additional Options

Examples of optional equipment that may be fitted to the enclosure are as follows:


• A suitably rated contactor(s) when switching is specified.
• A brass gland plate attached to the bottom of the box for cable termination.
• A switch unit for a 2 part photocell.
• A photocell connector block.
• Neon indicators on incoming and / or outgoing circuits.
• A suitably rated anti-condensation heater - 15, 20 or 60W.
• Terminal Blocks to accept cable sizes greater than 16mm².
• Override switch, toggle or illuminated rotary.

JMA Control Panel

© 2014 James M Anderson Limited. All Rights Reserved.

Facebook Skype Ebay Go to top Downloads

Terms & Conditions


Privacy